Installation:
(1) Disconnect shock by hose and remove
blow by the tube off with doladowanego.
(2) disconnect the hose, air bypass valve shall be provided upstream and remove valve.
(3) disconnect the hose outlet turbo and throttle hose and remove doladowanego.
(4) Delete left blow by hose. Cut the rubber hose, provided that 12f up to 650 mm and install it using the supplied three-way fitting to blow right by using the hose as shown.
-To prevent distortion of the throttle, the snake, the snake on the throttle body route and secure the hose to the exhaust manifold zip ties provided.
-Secure the ends of the hose from the links provided that zip.
(5) Install the collar tabs intercooler using provided that the gasket and screws as shown.
Venting to the atmosphere
(1) Install plugins 34 Ø provided that in the air through the hose and hose assembly factory.
(2) install the GReddy Blow Off valve using a provided that the gasket and bolts.
Circulation type
(1) Remove the factory air bypass hose.
-If you delete the character snake page pipe snakes.
(2) Cut the serpent bypass air as shown and reinstall the hose pipe.
(3) Install, provided that the pipes return hose bypass cutting air, as shown.
-Route of return pipe under the doladowanego the left square bracket as shown.
(4) Remove the funnel discharge is excluded from the blow off valve and install valve intercooler using provided that the seal and valve.
-Annex you can easily turn off. Make sure not to damage the ring.
(5) reinstall the doladowanego and connect turbo outside let hose and throttle body hose.
(6) cable connections return blow valve with hose provided 34 Ø silicone.
(7) the vacuum hose to the top of the Again in blow valve and emblem on the top cover.
(1) Inspection of the installation. Reconnect the negative terminal of the battery and run the engine.
(2) check and make sure that there is no air of leeks, temporary problems or incorrect sound.
(3) a slightly rev up the engine a couple of times to determine whether works blow off valve.
Download here